Guest WAPT-User Report post Posted June 24, 2008 Hello, I'm trying to setup a test scenario to gather metrics about response time over a specified interval and I am looking for assistance. Specifically, I wan't to setup the following: 1. One user, logging into a site, clicking on a couple of links, then logging out. 2. Wait 15 minutes 3. Goto Step 1 above. Basically, I want to perform the same transaction every 15 minutes for a day or two to get a baseline of how the application/network/etc are performing from a response time perspective. I am able to setup a user profile and get my test scenario configured (split out between Initial, Main, and Final), but I don't see anywhere I can configure the "wait-between-iterations" value. From what I can tell, WAPT appears to re-run each user every 10 seconds. Is there a way to change this? Let me know if there are any questions. Thanks, WAPT-User Quote Share this post Link to post Share on other sites
Guest angela Report post Posted June 25, 2008 Hello, I'm trying to setup a test scenario to gather metrics about response time over a specified interval and I am looking for assistance. Specifically, I wan't to setup the following: 1. One user, logging into a site, clicking on a couple of links, then logging out. 2. Wait 15 minutes 3. Goto Step 1 above. Basically, I want to perform the same transaction every 15 minutes for a day or two to get a baseline of how the application/network/etc are performing from a response time perspective. I am able to setup a user profile and get my test scenario configured (split out between Initial, Main, and Final), but I don't see anywhere I can configure the "wait-between-iterations" value. From what I can tell, WAPT appears to re-run each user every 10 seconds. Is there a way to change this? Let me know if there are any questions. Thanks, WAPT-User Hi! You can definitely set any time between iterations, not only 10 seconds. You can do this on Profile properies page - > Iterations - > with interval.. box. Please note that "iteration" means one pass of the requests from Main section only, so you need to place all your requests, including login and logout, into the Main section. Quote Share this post Link to post Share on other sites